 |
|
|
 |
|
 |
 |
●Adequately loosen the nut on the shaft bolt. Open out the guide to the sides and lift it up to remove it. ●It is not necessary to remove the nut. |
|
|
|
|
 |
 |
●Temporarily tighten the nut on the shaft bolt and secure the roller to the fl oor with anchors. ●It is convenient to align the mark at the center of the bracket with a chalk line. |
|
|
|
|
 |
 |
●Place the pipe on the roller. ●Check that the anchors are fully tightened and slightly loosen the nut on the shaft bolt. |
|
|
|
|
 |
 |
●Gently push the bolt grooves in the guide into position on the shaft bolt. ●The guide is set on the bracket when it clicks in place. ●Check that the guide is correctly set and fully tighten the nut on the shaft bolt. |
